An optic-ready stripped slide for the Glock 23 Gen 1-3 (.40 S&W). Drops onto any factory or Gen 1-3 Glock 23 frame; not compatible with Gen 4/5 due to recoil spring assembly differences.

Built by Live Free Armory in Melbourne, Florida from 416 stainless steel and finished in Cerakote. The body is heat treated to 38-42 HRC for predictable wear over thousands of rounds.

• Caliber: .40 S&W
• Fits: Glock 23 Gen 1-3 frames
• Optic cut: Trijicon RMR footprint
• Iron sight cuts (standard Glock sight set)
• Rear serrations for press checks and slide manipulation
• Side and top relief cuts for weight reduction and barrel display
• Material: 416 stainless steel, 38-42 HRC
• Finish: Cerakote
• Not ported — do not pair with a ported barrel

Mounting hardware: Cover plate screws are 6-32 × 1/3"; RMR optic screws are 6-32 × 7/16". Use the manufacturer-supplied screw kit that ships with your optic and apply blue Loctite (242 or equivalent) before torquing to spec.

Verify your barrel's chamber dimensions before final assembly. Aftermarket barrels may run tighter tolerances than factory, so run a function check with snap caps prior to live fire.

DISCLAIMER: "GLOCK" is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. and GLOCK Ges.m.b.H. Neither 3CR Tactical nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of "GLOCK" on this page is merely to advertise the sale of GLOCK pistols, parts, or components. For additional genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit www.glock.com.