Looking for a Glock 32 slide? This optic-ready stripped slide fits Glock 23 and Glock 32 Gen 1-3 frames. The bullnose profile, full iron-sight cuts, and RMR optic footprint give you a clean base for a .40 S&W or .357 SIG build with or without a red dot.

Frame Compatibility

Fits OEM Glock 23 and Glock 32 Gen 1-3 frames. Compatible with standard Glock 23 Gen 1-3 slide completion kits and barrels. Not cut for Gen 4/5 dual recoil systems.

Glock 23 or Glock 32: Same Slide, Your Choice of Caliber

The Glock 23 (.40 S&W) and the Glock 32 (.357 SIG) share the same compact slide. The barrel sets the caliber: .357 SIG is a necked-down .40 S&W case with the same case head, so the breech face is the same. Pair this slide with a Glock 23-pattern .40 S&W barrel or a Glock 32-pattern .357 SIG barrel. Many owners run one slide and keep both barrels on hand.

Finish

Black nitride over U.S.-sourced 416 stainless steel, heat-treated for wear life.

Features

• Bullnose profile with rounded front contour
• RMR optic cut, 6-32 thread mounting (recommend 6-32 x 1/3" cover plate / 6-32 x 7/16" optic screws)
• Front and rear diagonal serrations for confident manipulation
• Iron sight cuts pre-milled for standard Glock-pattern sights
• U.S.-machined 416 stainless steel
• Pairs with the 3CR Tactical Slide Completion Kit and any Glock 23-pattern barrel

Stripped slide only — internals, cover plate, and barrel not included. Confirm your frame is Gen 1-3 before ordering; Gen 4/5 frames are not compatible with this recoil-rod profile.

DISCLAIMER: "GLOCK" is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. and GLOCK Ges.m.b.H. Neither 3CR Tactical nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of "GLOCK" on this page is merely to advertise the sale of GLOCK pistols, parts, or components. For additional genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit www.glock.com.