Stripped RMSc-cut slide for the Glock 43 and 43X, machined from 416 stainless and finished in salt-bath black nitride, with a knurled grip texture front and rear for a positive hold on press checks. Drops onto factory Glock 43, 43X and 43X MOS single-stack frames with no fitting. The optic cover plate comes installed.

Features

• RMSc optic cut, direct mount (Shield RMSc, Holosun 407K/507K, Sig Romeo Zero and similar)
• Knurled grip serrations, front and rear
• Black nitride finish over 416 stainless
• Iron-sight dovetails in the factory locations
• Optic cover plate installed

What you'll need to supply

• A Glock 43/43X 9mm barrel
• A Glock 43/43X slide completion kit
• Sights, and an RMSc-footprint optic if you want one

Fitment — Glock 43, 43X and 43X MOS frames, and third-party frames built to the same pattern. Verify your red dot uses the RMSc footprint — RMR-pattern optics will not bolt up to this cut. Screw specs for reference: cover plate 6-32 × 1/3″, optic 6-32 × 7/16″.

DISCLAIMER: GLOCK is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. or GLOCK Ges.m.b.H. Neither 3CR Tactical nor this site are affiliated with, or endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of "GLOCK" on this page is merely to advertise the sale of aftermarket GLOCK pistol components. For genuine GLOCK, Inc. products, visit www.glock.com.