This V-Block barrel retainer attaches to the Ruger 10/22 receiver and stabilizes the barrel against the receiver shoulder, eliminating the droop and side-to-side play that can show up after a barrel swap or repeated takedowns. Machined from 6061-T6 aluminum and finished matte black, the retainer mounts with two hex screws and ships with the Allen wrench needed to install.

Specs:

• 6061-T6 aluminum, matte black finish
• V-Block width: 0.875"
• Mounting screws: 1.6875" hex
• Allen wrench included
• Fits Ruger 10/22 receivers — factory and aftermarket spec

Install: Remove the factory barrel-band retainer, drop the V-Block into place against the barrel journal, and torque the two hex screws evenly to seat the barrel against the receiver. Recheck point of impact after the first 25 rounds — a properly tensioned V-Block typically tightens groups noticeably versus the factory wedge.

Pair with an aftermarket bull or fluted barrel and a bedded stock for a complete accuracy package on bench guns or rimfire trainers.