The Ruger BX-Trigger is a genuine Ruger drop-in trigger assembly for 10/22 rifles and 22 Charger pistols. It cuts the pull weight to about 2.75 lb, down from the roughly 6 lb of the standard trigger, and gives a crisper, lighter break.

Because it is a complete factory assembly, you swap the whole trigger group instead of replacing individual springs or sears. Push out the two receiver cross pins, drop out the old trigger group, set the BX-Trigger in place and reinstall the pins. No fitting or gunsmithing is needed.

Features:

• Fits: Ruger 10/22 rifles and Ruger 22 Charger pistols
• Genuine Ruger factory part
• About 2.75 lb pull weight (standard is about 6 lb)
• Crisper, lighter break than the standard trigger
• Complete drop-in trigger group
• No gunsmithing required

A lighter trigger helps most on the bench and in small-game shooting, where a clean break matters more than speed. It also suits a training rifle used to teach new shooters good trigger control.

After installing, run a function check with the firearm unloaded: the safety should block the trigger, the trigger should reset when you cycle the bolt, and the hammer should not follow the bolt forward. Do this before you load any ammunition.