Fits Gen 1–3 Glock 19 compatible frames — OEM or aftermarket. The LFA Raptor slide is machined in Melbourne, FL from US-sourced stainless steel, then finished in tungsten Cerakote for durability and a uniform matte look.

Cut for the Trijicon RMR footprint and built up as a complete upper with internals, cover plate, and tall sights pre-installed. Pick your barrel from the options above at checkout.

Features:

• LFA Raptor RMR-cut slide, US-machined stainless
• Tungsten Cerakote finish
• Trijicon RMR footprint with cover plate installed
• 3CR Tactical slide completion kit installed
• Tall polymer suppressor-height sights — co-witness with an optic
• Barrel selected at checkout

Apply lubricant to slide rails and barrel hood before first use. Run 200 rounds of 124-grain or heavier 9mm before moving to lighter loads. Confirm your lower is a Gen 1–3 Glock 19 pattern before install.

Mounting hardware:

• Cover plate screws: 6-32 × 1/3"
• Optic mounting screws: 6-32 × 7/16"

For optic installation, use the manufacturer-supplied mounting kit and apply blue thread locker (Loctite 242 or equivalent) to the screws before torquing to spec.

DISCLAIMER: "GLOCK" is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. and GLOCK Ges.m.b.H. Neither 3CR Tactical nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of "GLOCK" on this page is merely to advertise the sale of GLOCK pistols, parts, or components. For additional genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit www.glock.com.