Shop-assembled Glock 19 Gen 3 RMR-cut slide built and function-tested in our Florida shop. Aggressive front and rear knurled cocking grips on a black nitride blank, a full-length 9mm black nitride barrel, and tall (suppressor-height) sights for red-dot co-witness — drop-in fit with no gunsmithing required.

Fit: Glock 19 Gen 3 frames. Will not drop on Gen 4 or Gen 5 frames.

Features:

• Knurled-grip stripped slide blank, black nitride finish — aggressive front and rear cocking grips
• RMR-footprint optic cut with cover plate — fits Trijicon RMR / SRO and compatible red dots (Holosun 407C / 507C, etc.)
• 3CR Tactical slide completion kit pre-installed (firing pin, extractor, plunger assembly, recoil rod, cover plate)
• Full-length 9mm black nitride drop-in barrel
• Tall (suppressor-height) polymer sights pre-installed — co-witness with most RMR-footprint red dots
• Fully assembled and function-tested in our Florida shop — no gunsmithing required

Optic mounting screws (not included): use the screws supplied with your optic, or 6-32 × 1/3" for the cover plate and 6-32 × 7/16" for the optic when mounting on top of the plate.

Verify Glock 19 Gen 3 frame compatibility before install. Cycle the action by hand to confirm full lockup, then run a 100–200 round break-in with quality 115–124gr FMJ before relying on the slide for duty or carry.

DISCLAIMER: "GLOCK" is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. and GLOCK Ges.m.b.H. Neither 3CR Tactical nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of "GLOCK" on this page is merely to advertise the sale of GLOCK pistols, parts, or components. For additional genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit www.glock.com.