Shop-assembled Glock 19 Gen 3 RMR-cut slide built and function-tested in our Florida shop. Aggressive front and rear knurled cocking grips on a black nitride blank, a gold TiN (titanium nitride) crown/flush 9mm barrel, and standard-height polymer sights.

Fit: Glock 19 Gen 3 frames. Will not drop on Gen 4 or Gen 5 frames.

Features:

• Knurled-grip stripped slide blank, black nitride finish
• RMR-footprint optic cut with cover plate — fits Trijicon RMR / SRO and compatible red dots (Holosun 407C / 507C, etc.)
• 3CR Tactical slide completion kit pre-installed (firing pin, extractor, plunger assembly, recoil rod, cover plate)
• Gold TiN (titanium nitride) crown/flush 9mm drop-in barrel
• Standard-height polymer sights pre-installed — these are not suppressor-height and will not co-witness through a mounted optic
• Fully assembled and function-tested in our Florida shop

Finish note: TiN is a decorative coating; expect contact wear at the chamber face and lugs over time. Performance is unaffected.

Optic mounting screws (not included): 6-32 × 1/3" for the cover plate and 6-32 × 7/16" for the optic on the plate.

Verify Glock 19 Gen 3 frame compatibility before install. Cycle by hand to confirm full lockup, then run a 100–200 round break-in with quality 115–124gr FMJ.

Frame parts kit included

This build is bundled with the 3CR Tactical frame completion kit — the lower components needed to finish a frame, bundled below what the kit sells for on its own.

• Trigger with trigger bar
• Trigger housing with ejector (Gen 3)
• Trigger spring, trigger pin and trigger housing pin
• Connector
• Magazine release with spring (G17/G19)
• Slide stop release with spring
• Slide lock with springs
• Locking block pin

Kit fitment — the frame parts kit is Gen 3: the trigger housing ships with the Gen 3 ejector. The slide itself fits Glock 19 Gen 3 frames.

What you'll still need to supply

• A Glock 19 Gen 3 frame and a magazine

This is a slide assembly and a frame parts kit. It is not a complete pistol and does not include a frame.

DISCLAIMER: "GLOCK" is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. and GLOCK Ges.m.b.H. Neither 3CR Tactical nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of "GLOCK" on this page is merely to advertise the sale of GLOCK pistols, parts, or components. For additional genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit www.glock.com.