Shop-assembled and function-tested RMR-cut slide for Glock 19 Gen 3 frames, built in our Florida shop. Aggressive knurled front and rear cocking grips, a Rose Gold PVD crown/flush-cut 9mm barrel, and tall (suppressor-height) sights for red-dot co-witness — drop-in fit with no gunsmithing required.

Features

• Knurled-grip stripped slide blank, black nitride finish — aggressive front and rear cocking grips
• RMR footprint optic cut with cover plate for Trijicon RMR / SRO and compatible red dots (Holosun 407C, 507C, etc.)
• 3CR Tactical slide completion kit pre-installed (firing pin, extractor, plunger assembly, recoil rod, cover plate)
• Rose Gold PVD crown/flush-cut 9mm drop-in barrel — chambered in 9mm Luger
• Tall (suppressor-height) polymer sights pre-installed and aligned — co-witness with most RMR-footprint red dot optics
• Fully assembled and function-tested in our Florida shop — no gunsmithing required
• Manufacturer Part Number: ASSM-G19-RMR-02AG-BN-RG

Specifications

• Caliber: 9mm Luger
• Compatible host: Glock 19 Gen 3 frames
• Slide finish: Black nitride
• Barrel: 9mm Rose Gold PVD, crown/flush cut (non-threaded)
• Optic cut: RMR footprint
• Sights: Tall / suppressor-height polymer

Finish note

The Rose Gold PVD barrel finish is a decorative coating. Like all PVD/TiN coatings, it can show wear at points of metal-to-metal contact (such as the barrel hood and locking lugs where the barrel meets the slide) over time with use. This is normal and does not affect reliability or function.

Optic mounting screws (not included)

If you are mounting a red dot, we recommend using the screws supplied with your optic kit. The RMR cover plate uses 6-32 × 1/3"; optic mounting uses 6-32 × 7/16". Most Trijicon, Holosun, and aftermarket kits include the correct length. Hardware is not included with this slide.

Break-in and care

Lube all slide rails and contact surfaces before first use. Run approximately 200 rounds of standard 9mm ammunition during break-in before moving to duty or self-defense loads. Confirm your lower is a Glock 19 Gen 3 pattern before installation.

DISCLAIMER: "GLOCK" is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. and GLOCK Ges.m.b.H. Neither 3CR Tactical nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of "GLOCK" on this page is merely to advertise the sale of GLOCK pistols, parts, or components. For additional genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit www.glock.com.