Shop-assembled Glock 19 Gen 3 RMR-cut slide built and function-tested in our Florida shop. Aggressive front and rear knurled cocking grips on a black nitride blank, a polished stainless steel crown/flush 9mm barrel, and standard-height polymer sights — drop-in fit with no gunsmithing required.

Fit: Glock 19 Gen 3 frames. Will not drop on Gen 4 or Gen 5 frames.

Features:

• Knurled-grip stripped slide blank, black nitride finish
• RMR-footprint optic cut with cover plate — fits Trijicon RMR / SRO and compatible red dots (Holosun 407C / 507C, etc.)
• 3CR Tactical slide completion kit pre-installed (firing pin, extractor, plunger assembly, recoil rod, cover plate)
• Polished stainless steel crown/flush 9mm drop-in barrel
• Standard-height polymer sights pre-installed — these are not suppressor-height and will not co-witness through a mounted optic
• Fully assembled and function-tested in our Florida shop

Finish note: The barrel is bare polished stainless — no PVD/TiN coating to wear off; expect natural carbon and brass marking from use.

Optic mounting screws (not included): 6-32 × 1/3" for the cover plate and 6-32 × 7/16" for the optic on the plate.

Verify Glock 19 Gen 3 frame compatibility before install. Cycle by hand to confirm full lockup, then run a 100–200 round break-in with quality 115–124gr FMJ.

DISCLAIMER: "GLOCK" is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. and GLOCK Ges.m.b.H. Neither 3CR Tactical nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of "GLOCK" on this page is merely to advertise the sale of GLOCK pistols, parts, or components. For additional genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit www.glock.com.