This 3-piece tool kit for Glock pistols covers the three jobs that come up most often at the bench: swapping a front sight, pushing frame pins, and stripping magazines for cleaning. It is sized for the Glock 17, 19, 26, 27 and 43, and it keeps the right tools in one place instead of improvising with a screwdriver or a nail.

What's in the kit:

• Front sight tool — holds and turns the front sight screw from inside the slide when you install or replace a front sight.
• Pin punch — drifts the trigger pin, trigger housing pin and locking block pin during detail stripping and reassembly.
• Magazine disassembly tool — releases the magazine floor plate so you can remove the spring and follower for cleaning or a base-plate swap.

Fits: Glock 17, 19, 26, 27 and 43 pistols.

Good for: sight upgrades, routine cleaning and inspection, installing a slide completion kit or frame parts, and swapping magazine base plates or extensions.

Before you start, confirm the pistol is unloaded and the magazine is removed. If you are new to detail stripping, work slowly and keep small springs and pins in a parts tray.

DISCLAIMER: GLOCK is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. or GLOCK Ges.m.b.H. Neither 3CR Tactical nor this site are affiliated with, or endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of "GLOCK" on this page is merely to advertise the sale of aftermarket GLOCK pistol components. For genuine GLOCK, Inc. products, visit www.glock.com.