A stripped Glock 26 Gen 3 slide, machined from 416 stainless and finished in FDE PVD. Front and rear cocking serrations, factory-pattern iron sight dovetails, and the Trijicon RMR footprint cut directly into the slide with a cover plate installed, so it runs iron-sight-only until you mount an optic.

What's included

• Slide, RMR optic cut, FDE PVD finish over 416 stainless
• Optic cover plate, installed

What you'll need to supply

• A Glock 26 Gen 3 slide completion kit — striker, extractor, safety and recoil assembly
• A 9mm subcompact barrel and sights
• A frame. This is a slide only, not a complete pistol.

Fitment — Glock 26 Gen 1–3 frames and third-party subcompact frames built to the same pattern (including Polymer80 PF940SC). Use a Gen 3-spec recoil spring assembly; Gen 4/5 recoil assemblies use different geometry.

Optic & cover-plate hardware: RMR footprint (Trijicon RMR, Holosun 407C/507C, SRO and similar). Screw specs for reference: cover plate 6-32 × 1/3″, optic 6-32 × 7/16″. Optic sold separately.

DISCLAIMER: GLOCK is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. or GLOCK Ges.m.b.H. Neither 3CR Tactical nor this site are affiliated with, or endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of "GLOCK" on this page is merely to advertise the sale of aftermarket GLOCK pistol components. For genuine GLOCK, Inc. products, visit www.glock.com.