The Rugged Suppressors 3 Port muzzle brake is a recoil-mitigation device for unsuppressed shooting, machined with the Rugged Dual Taper Locking System interface so it doubles as a suppressor mounting surface for the Radiant762, Surge 7.62, Razor 7.62, and Micro30 cans.

Features:

• 1/2x28 thread pitch — fits 5.56 AR-15 barrels and pin-and-welds to bring 14.5" barrels to 16"+
• .30 cal aperture — also runs on .308 / 7.62 hosts
• Dual Taper Locking System (DTL) — mounts compatible Rugged suppressors directly
• 3-port design — reduces felt recoil and limits muzzle rise
• Heat-treated steel construction with corrosion-resistant finish

Note: The DTL interface is what makes this brake "Rugged-compatible" as a suppressor mount. If you are running a non-Rugged can or no can at all, the brake still works as a standalone recoil-reduction device.

Verify your barrel thread pitch (1/2x28 for 5.56, 5/8x24 for most .30 cal) before install. Use a crush washer or peel washers for proper timing; thread sealant is optional. Re-check timing and torque after the first 50 rounds.