Genuine Glock factory replacement slide cover plate — part number SP00133 — for Glock 17, 19, 22, 23, 26, 27, 34, and 35 (and other full-size, compact, and subcompact Glocks except Glock 42 and Glock 43 subcompacts, which use their own smaller plate). Drop-in fit with no fitting required; snaps into the rear of any standard-frame Glock slide over the striker and spacer sleeve assembly.
Made by Glock to the same tolerances as the plate installed in every new pistol from the factory. Serves as a direct replacement when the original goes missing during disassembly, cracks under repeated takedown cycles, or gets swapped out temporarily for an aftermarket engraved, MOS, or suppressor-height plate.
Install by locking the slide back, depressing the spring-loaded spacer sleeve at the rear, and sliding the plate down into its rails until fully seated. Verify the plate sits flush and does not rock before racking the slide.
DISCLAIMER: "GLOCK" is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. and GLOCK Ges.m.b.H. Neither 3CR Tactical nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of "GLOCK" on this page is merely to advertise the sale of GLOCK pistols, parts, or components. For additional genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit www.glock.com.
