Assembled Glock 19 Gen 3 Slide — FDE PVD with 9mm Barrel

Drop-in assembly built for OEM Glock 19 Gen 3 frames and most Glock 19 Gen 3-compatible aftermarket lowers. The slide is CNC-cut, then PVD-coated in Flat Dark Earth at the atomic level for a finish that stands up to holster wear better than spray-on coatings.

RMR cut on top accepts a Trijicon-footprint optic or sits clean under the included cover plate. Front and rear cocking serrations give positive purchase. The matching 9mm barrel ships installed and headspaced.

• Material: stainless steel slide and 9mm match-grade barrel
• Finish: FDE PVD coating
• Optic cut: Trijicon RMR with cover plate installed
• Cocking serrations: front and rear
• Internals: channel liner, striker assembly, recoil rod, 9mm barrel
• Fit: Glock 19 Gen 3 OEM and Glock 19 Gen 3-compatible aftermarket frames

Run 200 rounds of standard 9mm before judging cycling or lockup — short break-in is normal on any new aftermarket slide. Confirm frame rail dimensions if mounting on a non-Gen 3 lower.

DISCLAIMER: "GLOCK" is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. and GLOCK Ges.m.b.H. Neither 3CR Tactical nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of "GLOCK" on this page is merely to advertise the sale of GLOCK pistols, parts, or components. For additional genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit www.glock.com.