The RMR Cover Plate fits any Glock 17, 19, or 26 slide milled to the Trijicon RMR footprint — direct-mill MOS slides, aftermarket RMR-cut slides, and any slide using the standard RMR mounting pattern. Drop it in when you pull the optic for cleaning, transition back to iron sights, or want to protect the milled pocket from debris and moisture.

Machined from 6061-T6 aluminum with a black anodized finish, this plate keeps the low profile of a stock rear cover and won't add weight to the slide.

Specs & fit:

• Fits Trijicon RMR-footprint slides (Glock 17/19/26 MOS + aftermarket RMR cuts)
• 6061-T6 aluminum, black anodized
• (2) 4-40 x 3/16" mounting screws included
• 1/16" hex driver included
• Cerakote finish variants available on select runs

Install note: Torque the mounting screws snug — no thread-locker required for range use. If you cycle the plate on and off frequently, a drop of blue Loctite prevents backing-out under recoil. Verify iron-sight height clears the plate; taller suppressor-height sights sit above the plate profile without contact.

For Glock 17/19/26 RMR-cut slides only. Not compatible with RMSc-cut or Docter-cut slides.

DISCLAIMER: "GLOCK" is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. and GLOCK Ges.m.b.H. Neither 3CR Tactical nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of "GLOCK" on this page is merely to advertise the sale of GLOCK pistols, parts, or components. For additional genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit www.glock.com.