Threaded 9mm replacement barrel for the Glock 26 — drop-in fit on Gen 1 through Gen 5 OEM Glock 26 frames with no hand-fitting required. The 1/2x28 muzzle threads accept any standard 9mm compensator, thread protector, or suppressor direct-thread mount.

Hard black DLC finish over a 416 stainless steel barrel. DLC is harder than nitride and significantly more wear-resistant than cerakote, which matters on a subcompact carry gun that sees regular cycling. The barrel is +P rated for defensive loads.

Barrel specs:

• 9mm, 1:16 twist
• Black DLC finish on 416 stainless steel
• 1/2x28 threaded muzzle
• Knurled thread protector and O-ring installed
• +P rated for defensive loads
• Fits Glock 26 Gen 1-5 OEM frames

Use notes:

• Compatible with factory G26 slides and most aftermarket G26-cut slides
• Thread protector removes for direct-thread compensators or suppressor mounts
• Pair with a 3CR 9mm Micro Compensator for flat tracking on a subcompact
• For best concealment, leave the thread protector installed when not running a comp — the knurled cap sits flush at the muzzle

Clean the bore before first use, keep the lockup surfaces lubed for the first 100 rounds, and confirm function with your carry load before trusting it for daily use.

DISCLAIMER: "GLOCK" is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. and GLOCK Ges.m.b.H. Neither 3CR Tactical nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of "GLOCK" on this page is merely to advertise the sale of GLOCK pistols, parts, or components. For additional genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit www.glock.com.