This is a 2-pack of standard AR-15 receiver end plates. The end plate is the backing plate that sits between the lower receiver and the castle nut on a carbine receiver extension (buffer tube). It keeps the takedown pin detent and spring captured and gives the castle nut a flat surface to tighten against.
These are plain plates with no sling provision, so they suit builds where the sling attaches to the stock or handguard. Two in the pack means you have one for this build and a spare for the next, or a replacement if a plate gets bent or chewed up during a stock swap.
Made for standard mil-spec carbine receiver extensions that use a castle nut. If you need a sling point at the receiver, the ABTA13 dual sling-clip end plate is the alternative.
When installing, make sure the takedown detent spring is seated in the plate's channel before you tighten the castle nut, and confirm the rear takedown pin still opens and closes normally. Stake the castle nut once everything checks out.