The Glock Micro Compensator is threaded in the standard 9/16 x 24 thread pitch for .40 S&W/10mm caliber barrels. Commissioned off of our popular TBC 9mm micro compensator, this version for .40 S&W/10mm caliber Glocks will provide similar results.
It will work on most .40/10mm Glock barrels threaded for 9/16x24. The Micro Comp only adds about .45" to the end of your threaded barrel. Our comp was designed for the Glock 22 but will fit Glock 20/23/24/27/35. Although the comp was designed around the Glock 22, it will work very well with any .40/10mm Glock and will function with any open ended holsters in the event the gun is longer than the holster. Compensator mitigates recoil and keeps your gun flat throughout recoil.
Two included set screws (10-32x7mm) to ensure that the comp fits square with the slide on compatible threaded barrels.
Specifications:
Note: Comp is counter bored to thread close to the slide. As different barrels have different threaded sections, the fit may vary by barrel.
Have a 40-9 conversion barrel? Try out the original TBC 9mm compensator.
DISCLAIMER: This product is not manufactured, authorized, endorsed, or warranted by GLOCK. GLOCK does not warrant or represent that this product is compatible with GLOCK pistols.
DISCLAIMER: "GLOCK" is a federally registered trademark of GLOCK, Inc. and is one of many trademarks registered by GLOCK, Inc. and GLOCK Ges.m.b.H. Neither 3CR Tactical nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of any "GLOCK" trademarks on this page is merely to advertise the sale of pistols, parts, components or accessories that are compatible with GLOCK pistols. For genuine GLOCK, Inc. and GLOCK Ges.m.b.H. products and parts visit www.glock.com.
